/etc/default/rsync

1 개요

/etc/default/rsync

# defaults file for rsync daemon mode

# start rsync in daemon mode from init.d script?
#  only allowed values are "true", "false", and "inetd"
#  Use "inetd" if you want to start the rsyncd from inetd,
#  all this does is prevent the init.d script from printing a message
#  about not starting rsyncd (you still need to modify inetd's config yourself).
RSYNC_ENABLE=false

# which file should be used as the configuration file for rsync.
# This file is used instead of the default /etc/rsyncd.conf
# Warning: This option has no effect if the daemon is accessed
#          using a remote shell. When using a different file for
#          rsync you might want to symlink /etc/rsyncd.conf to
#          that file.
# RSYNC_CONFIG_FILE=

# what extra options to give rsync --daemon?
#  that excludes the --daemon; that's always done in the init.d script
#  Possibilities are:
#   --address=123.45.67.89		(bind to a specific IP address)
#   --port=8730				(bind to specified port; default 873)
RSYNC_OPTS=''

# run rsyncd at a nice level?
#  the rsync daemon can impact performance due to much I/O and CPU usage,
#  so you may want to run it at a nicer priority than the default priority.
#  Allowed values are 0 - 19 inclusive; 10 is a reasonable value.
RSYNC_NICE=''

# run rsyncd with ionice?
#  "ionice" does for IO load what "nice" does for CPU load.
#  As rsync is often used for backups which aren't all that time-critical,
#  reducing the rsync IO priority will benefit the rest of the system.
#  See the manpage for ionice for allowed options.
#  -c3 is recommended, this will run rsync IO at "idle" priority. Uncomment
#  the next line to activate this.
# RSYNC_IONICE='-c3'

# Don't forget to create an appropriate config file,
# else the daemon will not start.

2 같이 보기

• 리눅스 rsync